DYNMAST Pty Ltd.
Tel: 61 2 9829 4133
Fax: 61 2 9618 2990
E-mail: bernie@dynmast.com.au

 

uParch02

GPS OEM Genius 3 = FASTRAX Smart Antenna


The new Fastrax uPatch02 boasts impressive system performance.
The patch and ground plane are ideally matched for optimal signal reception. The superior sensitivity of the receiver provides continuous tracking and navigation now to extremely low signal levels with excellent cold start TTFF performance for demanding applications.

The uPatch02 is simple to use, just connect the power supply and the serial data and it is operational.

Integrated Module - GPS, 25mm Patch Antenna with ground Plane,
          Dual Regulators for receiver, RS232 Drivers,
          Power on Reset Circuit
 

GPS Performance specifications
                 See page 3 for details

GPS Protocol
                 NMEA 0183 Standard

Power Supply
                +2.9 to 7.0 Volts
                Recommended supply is 3 Volts
                Current 50mA typical

Antenna Resonance
               1578 MHz +3Mhz offset intentionally

Modules supports External I/O’s
With a 2 x 10 pin header, 1.27mm pitch
                 Power Supply input
                 Dual UART Ports
                 Selection for CMOS 2.7V
                 or RS232 Levels (default)
                 Boot mode select
                 External Wake-up
                 1PPS Output Four GPIO lines (0…3)

Physical Specification
                Size 45 x 45 x 9.7mm +/- 0.5mm
                Weight 18 grams
                Operating Temperature -40°C to +85°C
                Operating Humidity 0% to 95 % RH, non condensing
                Vibration 4G max

Note: Does not support DGPS correction input
HOME | GPS CATALOGUE | PRODUCT CATALOGUE