DYNMAST Pty Ltd.
Tel: 61 2 9829 4133
Fax: 61 2 9618 2990
E-mail: bernie@dynmast.com.au

wayLOGGERTM

GPS Data Logger

 

·        Low Cost – No operating costs

·        Easy To Use

·        Application Software Supplied

 

The wayLOGGER™ logs accurate GPS data (NMEA Strings) consisting of position (longitude & latitude), time, date, speed and heading down to a resolution of once per second (1Hz) from the time the unit is powered or the ignition of a vehicle is turned on.
 

The data collected is recorded on to a removable USB Memory Stick inserted at the front of the unit.

The removable USB stick contains a PC compatible file allowing you to remove the memory stick at any time to copy the files to your computers hard drive. 		  
The wayLOGGER™ is designed to be powered from any standard 8 to 28 Volt vehicle supply. It is typically mounted under the dash. The unit needs to remain accessible to remove & replace the card after each logging duration. Optionally the wayLOGGER™ can be mounted in a tamper proof box.
 
Application software is provided with the wayLOGGER™ as standard to allow you to playback the log files, select specific times or locations of interest and optionally to output the data to a map for visual display.

FEATURES

            Accurate GPS position, time & Speed logs
            Up to 7 years of storage capacity depending on the log rate
            Easy report generator for cost accounting
            Cost nothing to operate

DC CHARACTERISTICS

             Input Voltage:   8 to 28 VDC with Negative Earth
             DC Current:     Maximum 100 mA

GPS ANTENNA

            MicroNav Active GPS Antenna
            Frequency 1575 Mhz
            The GPS Antenna Connector is an SMA Female.
            DC Output on center contact is +5VDC
            Shield Ground
            Maximum current source is 40 mA

USB MEMORY STICK

           Any commercially Available USB Memory Stick (32 Mb or Larger)
           Stick to be used (Not supplied with module)

  


System Requirements

Application software is provided as standard with the wayLOGGER™ Kit.
The Minimum Computer System required is a PC with Microsoft® Windows® 95/98/2000/Me/XP and SVGA capable of 1024 x 768.

A single Serial COM Port is required if you wish to Transmit the GPS Data to a second PC with Mapping Software, or it can be used to Receive LOG Data from an external GPS Receiver. If your PC has 2 Serial COM Ports then you can run both the wayLOGGER™ Reporter and the Mapping Application on the one PC. The 2 Serial Ports should be interconnected using a Serial LAPLINK cable.

GPS Data & Logging Rate

The GPS Data used by this program is the NMEA standard RMC String.
This Program plays Only RMC strings from a GPS Receiver or other source.
The wayLOGGER™ Unit records RMC Data with the WGS 84 World Geodetic System.
The internal built in Place Data Base is referenced to the WGS 84 World Geodetic System.
If GPS data played by this Application is imported from another source, other than the wayLOGGER™
Unit, then it should also be referenced to the WGS 84 World Geodetic System.

The wayLOGGER™ is factory preset to log GPS data at a maximum rate of once per second,
providing up to 7 days worth of logging capacity (memory). The user can define the minimum log
rate which is 255 seconds / log. Logging data once every 5 seconds will allow you to log up to 28 days
of data on your 32MB memory stick.

                          
Note: The 9 Way D connector on the wayLOGGERTM box allows for other peripheral
GPS devices or program upgrades or custom modifications
HOME | GPS CATALOGUE | PRODUCT CATALOGUE